I have been asked to make a coffee table for a colleauge. He picked out and supplied an oak beam to use for legs and rails and a lovely waney oak board with a large knot in it which will be an amazing feature to this table.
The oak beam provided to me needed to be cut up to use for the legs and the rails. I used a table saw to machine to beam down into 4 chunks at 75mm x 75mm. I planed two faces flat and square with each other and used these edges with the table saw to cut the other sides of the timber square. I then check everything using a tri square and everything was spot on. The legs were 68mm x 68mm finished size before cutting the design into them. I used the remainder of the oak beam to cut out the rails.
I worked with my colleauge to design the table to his liking. He was certain on the design of the leg as it was his own. Plain rails was what he wanted so no detail on those. I set out marking the mortice and tenons which is the fixing method I am using for the rails to the tops of the legs.
After a lot of mallet and chisel work the mortices were chopped out and the tenons fit nice, tightly and all square. I placed the table top on the constructed legs and rails to give an idea of what the coffee table will look like when it is finished. The height was perfect and my colleauge is over the moon with it. I have some sanding left to do, glue the rails and legs together, 4 x buttons to make to fix the top to the rails and a generous 5 coats of danish oil which will bring out the beautiful lines and markings of this piece. There are many, many medullary rays in this table. Finished images are soon to follow!
The oak beam provided to me needed to be cut up to use for the legs and the rails. I used a table saw to machine to beam down into 4 chunks at 75mm x 75mm. I planed two faces flat and square with each other and used these edges with the table saw to cut the other sides of the timber square. I then check everything using a tri square and everything was spot on. The legs were 68mm x 68mm finished size before cutting the design into them. I used the remainder of the oak beam to cut out the rails.
I worked with my colleauge to design the table to his liking. He was certain on the design of the leg as it was his own. Plain rails was what he wanted so no detail on those. I set out marking the mortice and tenons which is the fixing method I am using for the rails to the tops of the legs.
After a lot of mallet and chisel work the mortices were chopped out and the tenons fit nice, tightly and all square. I placed the table top on the constructed legs and rails to give an idea of what the coffee table will look like when it is finished. The height was perfect and my colleauge is over the moon with it. I have some sanding left to do, glue the rails and legs together, 4 x buttons to make to fix the top to the rails and a generous 5 coats of danish oil which will bring out the beautiful lines and markings of this piece. There are many, many medullary rays in this table. Finished images are soon to follow!
No comments:
Post a Comment